Sizing details for Tapers
Designed for stretching/gauging these come in a few different styles and usually include 1 or 2 o-rings to help position.
With all styles the size/gauge is measured at the thickest point and therefore a 14mm taper would stretch up to 14mm.
When choosing a taper, don't just go for the size you're after but use a couple of smaller sizes first. This allows for easier use without a large end hanging out one side. As a general rule you'd only want to go up 1 - 2 sizes at a time/per taper.
Note: Most of our items are manufactured in the US and so are designed in Gauge/Inch sizes. We show the mm conversion for simplicity but some manufacturing variation can occur which shows up more in mm measurements.
How items are Measured
 |
Sizing Tool
Not sure what size you're after? Use our handy sizing tool to work out what you're currently using.
Step 1
Find a NZ $2 dollar coin, place it over the virtual coin below. Then use the smaller or larger button until your coin matches the virtual coin. Every computer is different but this will calibrate the charts so the sizes show correct on your screen.
 | |||
Step 2
Choose a chart from below to look and match your current body jewellery to get the correct size.
| Gauge | Length | Ball Size |
|
|
|
|
|
|